PorcelainPlus Speedbit
Product Overview
The PorcelainPlus Speedbit® is a tungsten carbide-tipped, spear point glass/tile drill bit that was specifically designed for drilling quickly and efficiently through porcelain, glass, and other hard surfaces for a variety of applications. Its speed and durability distinguish itself from other standard carbide bits. With a specially formulated mix of metals and superior designed carbide tip, the PorcelainPlus Speedbit® makes installations quicker and easier, therefore, more profitable.
Features
- Tungsten Carbide-Tipped, Spear Point Glass/Tile Drill Bit
- 3X Longer Life & 2X Faster than standard glass/tile bits
- Drills 10+ holes/bit*
- Faster Drilling Times (average 30 sec/hole)
- Specifically designed for porcelain, glass, and harder substrates
- Quick & easy startup, no wandering
- Can drill near edges of tiles/glass without cracking substrate
- Clean precise holes
- Handheld Drills Only- Recommended drilling speed of 2,300 rpms
*Based on PEI Class 5 porcelain tile with ¼” PorcelainPlus Speedbit®
Recommended for Use On
- Porcelain Tile
- Glass Tile
- Granite
- Brick
- Crystallized Glass
- Quartz
- Marble
- Concrete Block
- Ceramic Tile
- Glass*
- Mirrors*
*PorcelainPlus Speedbit Recommended
Applications
- Frameless Shower Doors
- Bathroom Partitions
- Tile
- Bathroom Accessories
- Masonry
- Decorative Glass*
- Glass*
- Mirrors*
*PorcelainPlus Speedbit Recommended
Product Info
| DIAMETER | 1/8″ | 3/16″ | 3/16″ | 1/4″ | 1/4″ | 5/16″ | 3/8″ | 1/2″ |
| OVERALL LENGTH | 2 3/8″ | 2 5/8″ | 6″ | 2 3/4″ | 6″ | 3″ | 3 1/8″ | 3 1/2″ |
| CODE | PPSB18 | PPSB316 | PPSB316-6 | PPSB14 | PPSB14-6 | PPSB516 | PPSB38 | PPSB12 |
Available individually or in a 4-piece Variety Pack (1/8”, 3/16”, 1/4″ & 5/16”) CODE: PPSBVAR18516.
3/16” x 4” is available upon request.
Instructions (for maximum durability):
- 1. DIP IN WATER before drilling and about every 5 seconds during drilling (more often when going thru harder materials). We find dipping in water is more effective at cooling the PorcelainPlus bits than spraying.
- 2. FIRM PRESSURE: Let the bit do the work - Do not apply excessive pressure. Place the drill bit on the specified mark, apply pressure, listen for a slight CRUNCH, and start your drilling process. Drill straight into hole and do not wiggle drill.
- 3. USE PROPER DRILLING SPEED: Speedbit: 2,300 rpms and slowed down while breaking through the hole. NOTE the higher speed for the Speedbit as most other spear point bits recommend slower speeds of 400-800 rpms.
- Handheld Drills Only.
- Do not use dull or damaged bit.
- Wear ANSI-approved safety goggles and heavy-duty work gloves during use and when handling bit.
